Use and Care Guide

4
CAUTION
SAFETY INFORMATION (CON’T)
Voltage: 120 VAC, 60 Hz
Amps: 11.7 Amps
ELECTRICAL SPECIFICATIONS
Grounding Pin
Metal
Screw
Cover of
Grounding
Box
Grounding Pin
Grounding Means
Adapter
C
A
B
SAVE THESE INSTRUCTIONS
Use this appliance only as described in the manual. Any other use is NOT recommended by the manufacturer and
may cause fire, electric shock or injury to persons.
• If possible, ALWAYS unplug this appliance when not in use.
• DO NOT operate any heater with a damaged cord or plug or aer the heater malfuncons.
• DO NOT operate any heater if it has been dropped or damaged in any manner. Disconnect power at service
panel and have heater inspected by a reputable electrician before reusing.
• Any repairs to this fireplace should be carried out by a qualified service person.
• Under no circumstances should this fireplace be modified. Parts having to be removed for servicing must be
replaced prior to operang this fireplace again.
• DO NOT use outdoors.
• This heater is not intended for use in bathrooms, laundry areas and similar indoor locaons. NEVER place heater
where it may fall into a bathtub or other water container.
• To disconnect this appliance, turn controls to the off posion, then remove plug from outlet.
• ONLY connect to properly grounded outlets.
• This appliance, when installed, must be electrically grounded in accordance with local codes, with the currebt
CSA C22.1 Canadian Electrical Code or follow the Naonal Electrical Code, ANSI/NFPA N0.70.
• To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on so surfaces, like
a bed, where opening may become blocked.
• The heaters MUST NOT be located immediately below a socket-outlet.
• ALWAYS plug heaters directly into a wall outlet/receptacle. NEVER use with an extension cord or relocatable
power tap (outlet/power strip).
• There is a thermostat protecve device provide inside of unit. If the inner temperature overheats or abnormal
heang occurs, the thermostat protecve device will cut off power supply to prevent damage or risk of fire.
• DO NOT place any objects on top of insert and top air intake vents as this will cause unit to overheat and can
cause a fire.
Electrical Connecon
• A 15-amp, 120-volt, 60 Hz circuit with a properly grounded outlet is
required. Preferably, the fireplace will be on a dedicated circuit as other
appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operaon. The unit comes
standard with 6-. three-wire cord, exing from the rear of the
fireplace. DO NOT exceed the current rang of the current tap. ALWAYS
plug heaters directly into a wall outlet/receptacle. NEVER use with an
extension cord or relocatable power tap (outlet/power strip).
• This heater is for use on 120 volts. The cord has a plug as shown
below. See illustraon for grounding instrucon. An adapter as shown
at C is available for connecng three-blade grounding type plugs to
two-slot receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if a three-slot
grounded receptacle is available.