Use and Care Guide

INSTALLATION INSTRUCTIONS
Hardware Used
AA
Bolt x 8
BB
Washer x 8
x 8
DD
Sink Clamp
EE
Lock Washer x 8
4. Place the sink clamps (DD) in the proper position
above the pre-threaded holes in the stone top.
Using Bolts (AA) Lock Washers (EE) and
Washers (BB) secure Sink Clamps (DD) to the
bottom of the Stone Top (B).
Repeated for the remaining sink.
Tip: check that the sink placement is well
centered front to back and side to side of the
stone top cut out before allowing the silicone
adhesive to dry. If the sink is not centered well
unscrew sink clamps, readjust the sink position
and re-tighten the sink clamps.
5
3. Apply silicone adhesive (not included) to
the top edge of Sink (D). With the help of
another adult, lower the sink onto the back
side of the stone top. Make sure the sink
over-flow hole is facing the front of stone top.
Be sure to align the sink well with the stone top
cut out allowing for equal stone overhang on the
front, back and sides of the ceramic sink (D).
Repeated for the remaining sink.
Note: To install the sink onto top correctly,
ensure the two “Back” stamps on the sink and
on the sub-top frame are on the same side,
and also make sure that the lines marked on
the sink and on the sub-top frame line up.
3
2
1
D
BACK
BACK
BACK
BACK
B
4
B
AA
EE
BB
DD
D
D
BACK
BACK
BACK
BACK