User's Manual

Page 2 of 12P/N 595123-01 Rev A 9/07
INSTALL THE PAK-LINK COMPUTER INTERFACE USB DRIVER
Before the PAK-LINK Computer Interface can be used with your computer, the USB Driver must be
2. Insert the CD disk in you computer.
Installer screen will appear. See
FIGURE 2.
COMPUTER REQUIREMENTS
The SCOTT Data Logger software is PC based and requires a minimum of WINDOWS
®
2000 or
higher and a 486 or faster processor with approximately ten (10) megabytes of free disc space. The
data log can be viewed within the Data Logger Software, but the computer must have Microsoft
®
Excel
®
installed in order to output and save a file of the data log. The Interface Unit plugs into a USB
2.0 port on the computer from which it gets its power.
installed. Install the USB Driver according
to the following steps:
1. Connect the PAK-LINK Computer
Interface to your computer using a USB
2.0 cable. Use of a peripheral powered
USB multi-port is not recommended.
The GREEN Light on the PAK-LINK
Computer Interface will turn on. If the
GREEN light does not turn on, there is
a problem with the interface. Remove
the interface from service and tag for
repair or replacement.
FIGURE 1
GREEN LIGHT WILL TURN
ON WHEN CONNECTED
FIGURE 2
CAUTION
THE INTERFACE UNIT GETS ITS POWER FROM THE USB PORT ON THE COMPUTER. WHEN USED
WITH A BATTERY POWERED LAP TOP COMPUTER, ALWAYS UNPLUG THE USB CABLE AFTER
USE TO PREVENT DRAINING THE POWER FROM THE BATTERY.