User's Manual

Page 3 of 12 P/N 595123-01 Rev A 9/07
3. Select “USB Driver” to install the USB driver on you computer needed to operate the PAK-LINK
Computer Interface. Follow the instructions on the screen. See FIGURE 3.
6. Make a note of the number of the COM Port that appears. See FIGURE 4.
NOTE
WRITE DOWN THE COM PORT NUMBER THAT APPEARS ON YOUR SCREEN. YOU WILL
NEED IT TO COMPLETE THE SETUP WHEN YOU RUN EITHER OF THE PROGRAMS
7. When your Computer displays “Found new Hardware” select OK.
4. When the USB Driver has been installed successfully, return to the Installer main screen.
5. Next to “COM Port,” click the “Refresh” button to display the COM Port that has been assigned
to the USB Connection. See FIGURE 4.
FIGURE 3
FIGURE 4