User's Manual

Page 4 of 12P/N 595123-01 Rev A 9/07
TO INSTALL DATA LOGGER SOFTWARE
1. Select “Pak-Alert Data Logger” to install the Data Logger program to download the log of events
from compatible PAK-ALERT Distress Alarm PASS Device. Follow the instructions on the screen.
You may need to close all other applications. See FIGURE 5.
2. When the installer creates a folder called “Scott Health & Safety” for the files, select “Continue.”
3. When the set up is completed successfully, select “OK.” You will return to the Installer screen.
4. When finished installing, close the Installer.
USING THE DATA LOGGER
DATE AND TIME
The date and time in the PAK-ALERT SE 7 distress alarm Data Logger software are set initially at
the factory. An internal back-up battery will maintain the date and time setting when the PASS
batteries are removed or changed. However, the date and time are automatically reset (Clock Re-
set) on the distress alarm after each time the data is downloaded. SCOTT strongly recommends
that each new respirator be run through the data log downloading procedure in this instruction to set
the date and time to your local time zone before the unit is put into service. This procedure should
also be followed if the respirator is left unused for more than six weeks.
FIGURE 5
NOTE
IF MICROSOFT EXCEL IS NOT INSTALLED ON YOUR
COMPUTER, THE MESSAGE SHOWN IN FIGURE 6 WILL
APPEAR. YOU WILL STILL BE ABLE TO INSTALL THE
SCOTT DATA LOGGER SOFTWARE AND VIEW THE
DATA LOG, BUT YOU WILL NOT BE ABLE TO OUTPUT
AND SAVE A FILE OF THE DATA LOG WITHOUT EXCEL
INSTALLED ON THE COMPUTER.
FIGURE 6