User's Manual

Page 18 of 24
P/N 595264-01 Rev B 06/15
COMMAND COMMS HEADSET
Optional Command Comms Headset SCOTT P/N 201229-01. The Command Comms
Headset is designed for two-way radio communication with a two-way portable radio.
This Command Comms Headset includes an earpiece speaker and a microphone
with adjustable arm. When connected to the radio, the headset will disable the radio
speaker and microphone and route all communication directly into the headset speaker
and microphone. The Command Comms Headset microphone operates using the
Push-To-Talk Button on the side of the BLUETOOTH LSM assembly.





Install and use as follows:
1. Turn off radio before installing the Command Comms Headset.
NOTE
INSTALLATION OF THE HEADSET WHILE THE RADIO IS ON MAY CAUSE THE
RADIO TO TRANSMIT CONSTANTLY, LOCKING UP YOUR RADIO SYSTEM. IF THIS
SHOULD HAPPEN, TURN OFF THE RADIO. THE RADIO CAN THEN BE TURNED
BACK ON, RESTORING NORMAL OPERATIONS.
2. Connect the Command Comms Headset cable to the BLUETOOTH LSM
according to the CONNECTING THE ACCESSORIES TO THE EPIC 3
BLUETOOTH LSM section of this instruction.
3. Place the Command Comms Headset around the back of the head with
both earpieces resting over the top of the ears. The speaker should be
positioned directly over the left ear. Adjust the microphone arm so that
the microphone is situated 1/2” or less from the mouth.
4. Turn on the portable two-way radio and verify that the headset is operating
properly. Speak into the headset microphone while pressing the Push-To-
Talk button on the BLUETOOTH LSM to transmit a message through the
portable radio.
5. Secure the cord from the Command Comms Headset so that it will not
present a hazard of snagging while in use. The cord must be positioned
so that it is not excessively loose or excessively tight and does not pull
on the BLUETOOTH LSM assembly any way.
If the unit does not operate properly, remove the unit from service and tag for repair
or replacement.
NOTE
THE COMMAND COMMS HEADSET DOES
NOT HAVE AN INDEPENDENT PUSH-TO-
TALK BUTTON. THE MICROPHONE ON
THE HEADSET OPERATES USING THE
PUSH-TO-TALK BUTTON LOCATED ON THE
BLUETOOTH LSM.
COMMAND COMMS HEADSET
SPEAKER
MICROPHONE
EARPIECE
EARPIECE
WARNING
DO NOT USE THE OPTIONAL COMMAND COMMS
HEADSET ACCESSORY IN APPLICATIONS
WHICH MAY ExPOSE IT TO HIGH HEAT
OR FLAME. IF USED IN A FIRE FIGHTING
APPLICATION, ALL ACCESSORIES AND CABLES
MUST BE CONTAINED WITHIN THE FIRE
FIGHTER’S TURNOUT GEAR FOR PROTECTION
FROM HEAT AND FLAME. ExPOSURE TO HIGH
HEAT OR FLAME MAY CAUSE THE COMMAND
COMMS HEADSET TO MELT OR BURN WHICH
COULD RESULT IN SERIOUS INJURY OR DEATH
TO THE USER.
WARNING
THE CORD FROM THE COMMAND COMMS
HEADSET MUST BE SECURED SO THAT IT WILL
NOT PRESENT A HAZARD OF SNAGGING WHILE
IN USE. THE CORD MUST BE POSITIONED
SO THAT IT IS NOT ExCESSIvELY LOOSE OR
ExCESSIvELY TIGHT AND DOES NOT PULL
ON THE BLUETOOTH LAPEL SPEAKER MIC
ASSEMBLY. FAILURE TO PROPERLY MANAGE
THE CORD FROM THE COMMAND COMMS
HEADSET MAY RESULT IN SNAGGING THE
CORD IN AN EMERGENCY SITUATION WHICH
COULD RESULT IN SERIOUS INJURY OR DEATH.