User's Manual

Page 8 of 28
P/N 595277-01 Rev E 10/17
QUESTIONS OR CONCERNS
If you have any questions or concerns regarding use of this equipment or if
you need additional copies of this or related User Instructions, contact your
authorized SCOTT distributor, or contact SCOTT at 1-800-247-7257 (or 704-
291-8300 outside the continental United States) or visit our web site at www.
scottsafety.com.
RADIO FREQUENCY INTERFERENCE (RFI)
When any electronic device is adversely affected by radio waves, Radio
Frequency Interference (RFI) is said to have occurred. All electronic devices
like the PAK-ALERT distress alarm may be subject to the effects of RFI,
most of which are temporary in nature. Users of the SCOTT AIR-PAK SCBA
with the integrated PAK-ALERT distress alarm must be familiar with the
normal operation of the distress alarm and must also be familiar with how
to identify and avoid the effects of RFI (see DETECTING AND AVOIDING
RADIO FREQUENCY INTERFERENCE on page 6). If RFI occurs to the
PAK-ALERT distress alarm, it may be caused by transmissions from hand-
held or personal radios where the radio antenna is touching or very close to
(less than 6 inches from) components of the PAK-ALERT distress alarm. It may
also be caused by transmissions from base stations or high-powered vehicle
mounted radios or any other powerful source of electromagnetic radiation.
INTRINSICALLY SAFE LISTING
The PAK-ALERT distress alarm with Integrated Locator transmitter, Model
Number 201160-SERIES, when installed on a SCOTT respirator, is listed by
SGS U.S. TESTING COMPANY INC. as intrinsically safe per ANSI/UL Std.
UL-913 for use in Class I, II, Division 1, Groups C, D, E, F, and G Hazardous
Locations,
only when powered by the batteries listed in this instruction or
indicated on the label on the Sensor Module.
To maintain Intrinsic Safety Listing, inspect the respirator with PAK-ALERT
distress alarm regularly per the Regular Operational Inspection procedures
in this instruction. Substitution of Components May Impair Intrinsic Safety.
To reduce the risk of ignition of a ammable atmosphere, batteries must
only be changed in an area known to be nonammable. To reduce the risk
of explosion, use only the approved batteries, do not mix old batteries with
unused batteries, or mix batteries from different manufacturers.
Report any operational malfunctions of the PASS function of this device
to the certication agency Safety Equipment Institute (SEI), 1307 Dol-
ley Madison Blvd. Suite 3A, McLean, VA 22101, [phone], FAX
[phone].
HAND HELD RECEIVER
NON-INCENDIVE LISTING
The SCOTT PAK-TRACKER LOCATOR SYSTEM Hand Held Receiver P/N
200397-02 is listed by SGS U. S. TESTING COMPANY, Inc. as Non-Incendive
per ANSI/UL Std. UL-1604 for use in Class I Division 2 Groups A, B, C, and
D hazardous locations. Temperature Code T4 (-25° C to 85° C). To maintain
the Non-Incendive Listing, the equipment must be inspected regularly per the
following Regular Operational Inspection procedures. Do not tamper with or
substitute components in any manner. Use only SCOTT Battery Pack P/N
200402-02. Open the battery compartment only in an area known to be free
of ammable or explosive hazards.
WARNING – Substitution of Components May Impair the Non-Incendive
Listing. To reduce the risk of ignition of a ammable atmosphere, battery must
only be changed in an area known to be nonammable. Do not substitute any
other battery or power source.
WARNING
FAILURE TO REGULARLY INSPECT THE HAND
HELD RECEIVER AS DESCRIBED IN THIS
INSTRUCTION OR FAILURE TO CORRECT ANY
DAMAGE FOUND, MAY IMPAIR THE SAFETY
OF THE EQUIPMENT. THE INSTALLATION OF
INCORRECT BATTERY OR SUBSTITUTION
OF ANY OTHER COMPONENTS MAY IMPAIR
THE SAFETY OF THE EQUIPMENT. IF THE
EQUIPMENT IS USED IN AN EXPLOSIVE OR
FLAMMABLE ATMOSPHERE, IMPAIRING THE
SAFETY OF THE UNIT MAY LEAD TO A FIRE
OR AN EXPLOSION WHICH COULD RESULT IN
SERIOUS INJURY OR DEATH.
WARNING
REPLACE HAND HELD RECEIVER BATTERY
PACK ONLY WITH SCOTT BATTERY PACK,
PART NO. 200402-02. DO NOT REMOVE, RE-
CHARGE, OR REPLACE BATTERY PACK WHILE
THE DEVICE IS IN A HAZARDOUS LOCATION.
REMOVING, RE-CHARGING, OR REPLACING
THE BATTERY PACK WHILE THE DEVICE IS IN
A HAZARDOUS LOCATION MAY LEAD TO A FIRE
OR AN EXPLOSION WHICH COULD RESULT IN
SERIOUS INJURY OR DEATH.
WARNING
LOOSE OR WORN ELECTRICAL CONDUCTORS
OR INSTALLATION OF INCORRECT BATTERIES
MAY CAUSE A HAZARDOUS SITUATION IN A
FLAMMABLE OR EXPLOSIVE AREA. IF THE
PAK-ALERT DISTRESS ALARM IS USED IN
AN AREA OF EXPLOSIVE OR FLAMMABLE
HAZARDS, FAILURE TO REGULARLY INSPECT
AS INSTRUCTED, FAILURE TO CORRECT
DAMAGE BEFORE USE, OR THE INSTALLATION
OF INCORRECT BATTERIES MAY LEAD TO A
FIRE OR EXPLOSION WHICH MAY RESULT IN
PERSONAL INJURY OR DEATH.
WARNING
SUBSTITUTION OF COMPONENTS MAY IMPAIR
INTRINSIC SAFETY. TO REDUCE THE RISK OF
IGNITION OF A FLAMMABLE ATMOSPHERE,
BATTERIES MUST ONLY BE CHANGED IN AN
AREA KNOWN TO BE NONFLAMMABLE. TO
REDUCE THE RISK OF EXPLOSION, DO NOT
MIX OLD BATTERIES WITH UNUSED BATTERIES,
OR MIX BATTERIES FROM DIFFERENT
MANUFACTURERS.
DRAFT
NOT FOR DISTRIBUTION