Amplifier System with Sub-woofer, Digital Docking Station FM Tuning Radio with Instruction Manual
PRECAUTIONS Follow the advice below for safe and appropriate operations. ON PLACEMENT Do not use the unit in places, which are extremely hot, cold, dusty, or humid. Place the unit on a flat and even surface. Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a cloth, or by placing it on a carpet. ON SAFETY When connecting and disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may damage it and create hazard.
LOCATION OF CONTROLS Unit 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 11 STANDBY/ ON button Infra-red remote sensor lens Speakers (2x) XBASS button (Bass boost) SOURCE button LCD display Clock back up battery cover AC power cord and FM antenna wire Blue leds (4x) Sub-woofer Headphone jack AUX IN jack universal dock and connector VOLUME + / - buttons (2x) TUNING▲/▼ buttons (2x) 12 13 1 14 2 15 3 4 5 6 7 8 9 10 Remote control 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16.
LCD display 7 5 6 4 3 2 1 8 20 9 19 10 11 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 12 13 14 15 16 17 18 MEMORY indicator for tuning presets MHz: Radio FM frequency unit Clock back-up battery indicator: It blinks when AC power supply is disconnected and batteries are installed.
INSTALLING BATTERIES Install the remote control batteries 1. 2. 3. Remove the battery compartment cover on the bottom of the remote control, by pressing the left tab to right while pulling the cover. Insert a 3V lithium battery (No. CR2025 or equivalent) with polarity (+) matching the mark inside the battery compartment cover. Replace the battery compartment cover.
OPERATING INSTRUCTIONS Connecting the power supply Insert the AC power cord plug into the mains socket with power source 230V AC ~ 50Hz. The unit is in standby mode and the clock starts to run. Clock setting When the unit is on, press STANDBY/ ON button to standby mode. Set the clock 1. Press and hold CLOCK button on the remote control for one second and “Hour digit” will flash. Note: You can also press and hold SOURCE button on the unit for one second. 2. Press VOLUME + / - buttons to set hour. 3.
RADIO OPERATION Listen to the radio 1. 2. 3. 4. 5. Press STANDBY/ ON button to turn on the unit. Press SOURCE button to select radio mode. / button on the Press and hold SKIP/ TUNING remote control for one second and then release the button. It will search up / down until a radio station is received. For fine-tuning, you can press SKIP/ TUNING / button repeatedly step by step. Note: You can also press TUNING▲/▼ on the unit. Adjust sound volume level by pressing VOLUME + / buttons up to maximum level 40.
LISTEN TO Install the 1. 2. 3. AND CHARGING INTERNAL BATTERY universal dock adapter Select the universal dock adaptor fitting to your model, from the next table. The adapter no. is marked at the back of the adapter. Install the adapter with two tabs facing the front, by pushing it down in the universal dock at the unit top. To remove the adapter for exchange of the others, press at the back of the adapter and pull it upward. Universal dock adapter no.
OTHER FUNCTIONS AUX IN function An AUX IN jack is provided with the cable to connect your external device such as earlier models, MP3 players or portable CD players for listening to the music through this unit. 1. 2. 3. Press STANDBY/ ON button to turn on the unit. Press SOURCE button to select AUX IN mode. Plug the cable (supplied) to AUX IN jack at the unit top and the other end to the headphone jack or LINE OUT of your external device. 4. Operate your external device to select and playback the music. 5.
MAINTENANCE Care and maintenance To clean the cabinet, unplug the unit and wipe off dust and stains with a soft cloth moistened with a mild soap and water solution only. Do not use benzene, thinner or similar chemicals to clean the cabinet. Notes on clock back up battery - Please note that this unit will not operate fully by battery power alone. The battery provides a back up system only in the event of an interruption of AC power supply. Cleaning the unit Do not use volatile chemicals on this unit.