User manual
GB-6
9. S-SHAPED TONEARM
10. TONEARM CLAMP AND REST
Use this rest to clamp the tone arm in position during transportation.
11. MOTOR OFF/Reverse BUTTON
Press this button to select Reverse/Forward playback.
Press the button for more than 1second to switch the motor off, and the LED will be flash.
Press the button again for more than 1 second again to switch the motor back on
12. 45 RPM ADAPTOR
Place on center spindle for playing 7” records with large center holes.
13. TONEARM LEVER
Allows you to move the tone arm the up or down.
14. ANTI-SKATE BUTTON
When a record is playing, a force is generated drawing the stylus towards the center of the
record. This control compensates for that force. Set the anti-skate button to the same
value as the stylus pressure.
15. COUNTERWEIGHT
Use the counterweight to balance the tone arm and to adjust the stylus pressure.
16. PHONO/LINE OUTPUT
Connect the turntable to any phono or line level input, using the supplied RCA/RCA cable.
Be sure to set the phono/line switch to the right position.
17. AC VOLTAGE SELECTOR
Make sure the selector is set properly.
18. POWER SWITCH
This switch turns the power on or off.
19. POWER CORD CONNECTOR
Used to connect the included power cord.
OPERATIONS
1. Push power button to switch the turntable on.
2. Place a record on the turntable mat. When playing a 45 rpm record with a large center
hole, place the 45 rpm adapter on the center spindle.
3. Set the rotation speed (33/45 rpm) to match the record.
4. Release the arm clamp
5. Set the cueing lever to the up position.
6. Press the Start/Stop button and the turntable platter will start to rotate.
7. Move the tone arm over the desired groove.
8. Set the cueing lever to the down position, the tone arm will descend slowly onto the record
and play begins.
9. Adjust the pitch to a desirable speed, move the pitch control slider towards the “+” or “-“ to
adjust the speed.
10. To pause play, lift the tone arm using the cueing lever.
11. When play is finished, raise the cueing lever, move the tone arm to the arm-rest and
secure the tone arm with the arm clamp.
12. Press the Start/Stop button to stop the platter rotating.
13. Push the Power button to switch the turntable off.