User manual

SYSTEM CONNECTION
A. Loosen one of the screws.
B. Slide the protection sheet to one side.
C. Select the required voltage using the switch.
D. Slide the protection sheet back to its original position and tighten the screw.
Note: Do not loosen the two screws at the same time.
Read the previous sections on system connections. Check whether the local power
voltage is consistent with the requirements of the unit and whether the unit is turned off
before making the connections. In order to avoid injury, use the correct wires. For more
details, refer to the illustrations in the previous section.
Speaker impedance must be between 4 ohms and 16 ohms.
After confirming the local power voltage type is consistent with the
requirements of the unit, you can connect the power wire.
GB-6