Operation Manual
06
GAMBLER | BIKE OWNER’S MANUAL 2015 BIKE OWNER’S MANUAL 2015 | GAMBLER
07
ENGLISH
ENGLISH
HEADSET
All Gambler 700 models are designed for a semi-integrated headset for 1.5”
headtubes with a 55mm outer diameter of the headtube.
For details please refer to the following drawing for reference only
There are several parts manufacturers offering headsets for this dimension of the
headtube.
ADJUSTABLE BB HEIGHT
- New shock chips for MY15.
- Two chips, left and right hand.
- Laser printing on LH side only, see
image below.
- Upper shock bolt the same as MY13.
- Lower shock bolt length increased
from 35mm to 36mm (new 36mm
bolt will also be compatible with
MY13 Gambler).
On the Gambler 700 you can
adjust the BB height above
ground for 10mm between its
2 positions by a geo-chip.
27.5” wheel size: Low position
is at a BB offset of +0mm, high
position is at +10mm offset.
26” wheel size: only high
position (at +10mm offset)
should be used.
In order to change the
setup please un-tighten the
shockmount bolt with a 6mm
allen key.
Flip the “geo-chip” on
both sides as shown in the
diagram and tighten the
shock mount bolt again with a
maximum tightening torque of
35Nm/308in/lbs.