Instruction manual

ManualsBrandsSCOTT ManualsMP3/MP4 playersI-CX 2

i-CX 2

ALARM CLOCK RADIO

WITH iPod DOCKING STATION

Instruction Manual

GB-1

PRECAUTIONS

Follow the advice below for safe and appropriate operations.

PLACEMENT

. Do not use the unit in places which are extremely hot, cold, dusty, or humid.

. Place the unit on a flat and even surface.

. Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a

cloth, or by placing it on a carpet.

. Do not place naked flame sources, such as lighted candles on the apparatus.

. Use the apparatus only in moderate climates (not in tropical climates).

. Do not expose the apparatus to dripping or splashing.

. Do not place objects filled with liquids, such as vases, on the apparatus.

SAFETY

. When connecting and disconnecting the AC power cord from the AC mains outlet, pull the plug and

not the cord itself. Pulling the cord may damage it and may be dangerous.

. The mains outlet and plug must always remain readily operable.

. When you are not going to use the unit for a long period of time, disconnect the AC power cord from

the AC mains outlet.

AC VOLTAGE

. Before use, check that the rated voltage of your unit matches your local voltage.

CONDENSATION

. When there is condensation inside the unit, it may not function normally.

. Let the unit stand for 1 to 2 hours before turning the power on, or gradually heat the room up and

dry the unit before use.

. Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation.

. Ensure that the ventilation is not impeded by covering the ventilation openings with items such as

newspapers, tablecloths, curtains, etc.

BATTERIES

. Pay attention to the environmental aspects of battery disposal.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The lightning flash with an

arrowhead symbol within a

triangle is a warning sign

alerting the user to the

presence of “dangerous

voltage” inside the unit.

ATTENTION: To reduce the risk

of electric shock, do not remove

the cover. There are no user

serviceable parts inside the unit.

Refer all servicing to qualified

personnel.

The exclamation mark

within a triangle is a

warning sign alerting the

user to the presence of

important instructions

accompanying the

product.

. In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting

it from mains supply.

Summary of content (4 pages)

PAGE 1
PRECAUTIONS ® i-CX 2 ALARM CLOCK RADIO WITH iPod DOCKING STATION Follow the advice below for safe and appropriate operations. PLACEMENT . Do not use the unit in places which are extremely hot, cold, dusty, or humid. . Place the unit on a flat and even surface. . Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a cloth, or by placing it on a carpet. . Do not place naked flame sources, such as lighted candles on the apparatus. .
PAGE 2
TABLE OF CONTENTS POWER SUPPLY PRECAUTIONS TABLE OF CONTENTS BOX CONTENTS LOCATION OF CONTROLS POWER SUPPLY BASIC OPERATION RADIO OPERATION PLAYING AN iPod AND CHARGING THE INTERNAL iPod BATTERY AUX IN FUNCTION AUX OUT FUNCTION MAINTENANCE TROUBLESHOOTING GUIDE TECHNICAL SPECIFICATIONS 1 2 2 2 3 3 4 5 6 6 6 7 7 BOX CONTENTS 1. Unit 2. Adapters for different iPod models (7x) 3. Instruction manual AC power supply Insert the AC power cord into the AC mains outlet with a 230V AC ~ 50Hz power source.
PAGE 3
Note: • While the buzzer alarm volume is fixed and cannot be adjusted, the music alarm volume can be adjusted to your desired level using the VOLUME dial. • If iPOD/AUX mode is selected, make sure the iPod is inserted in the docking station and the volume is set to a suitable level. Snooze function When the alarm sounds, press the SNOOZE button to stop the alarm temporarily and it will sound again after 9 minutes. To cancel the SNOOZE function and repeat the alarm the next day, press the AL SET/OFF button.
PAGE 4
TROUBLESHOOTING GUIDE AUX IN FUNCTION This unit has an AUX IN jack, which allows you to connect external audio devices such as MP3 players or earlier iPod models. 1. Connect a 3.5mm stereo connection cable (not supplied) to the AUX IN jack on the rear of the unit and the headphones/line out jack on your external audio device. 2. Slide the AM/FM/iPod/AUX switch to iPOD/AUX. 3. Operate your external audio device to select and play music. 4.