i-CX6 DUAL ALARM CLOCK RADIO WITH iPod DOCKING STATION Instruction Manual
PRECAUTIONS Follow the advice below for safe and appropriate operations. PLACEMENT . Do not use the unit in places which are extremely hot, cold, dusty, or humid. . Place the unit on a flat and even surface. . Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a cloth, or by placing it on a carpet. . Do not place naked flame sources, such as lighted candles on the apparatus. . Use the apparatus only in moderate climates (not in tropical climates). .
TABLE OF CONTENTS PRECAUTIONS TABLE OF CONTENTS BOX CONTENTS LOCATION OF CONTROLS POWER SUPPLY BASIC OPERATION RADIO OPERATION PLAYING AN iPod AND CHARGING THE INTERNAL iPod BATTERY AUX IN FUNCTION AUX OUT FUNCTION MAINTENANCE TROUBLESHOOTING GUIDE TECHNICAL SPECIFICATIONS 1. Unit 2. Remote control with battery 1 2 2 2 3 4 6 6 8 8 8 9 9 BOX CONTENTS 3. Adapters for different iPod models (7x) 4. Instruction manual LOCATION OF CONTROLS Unit 1. Handle 1 2 18 2. Docking station for iPod 19 3 3.
Remote control 1. MUTE 2. STANDBY/AL OFF/RESET 1 / M+ (play/pause/memory up) 3. 2 4. DISP (display) 3 5. MENU/MEM/CLK SET 4 6. REPEAT/M- (memory down) 7. SHUFFLE 5 6 8. ALBUM / 7 9. CHAPTER +/8 10. ALARM SET 1/2 11. FUNC (function) 9 12. iPod mode 13. MENU / 14. STOP/BAND 10 15. /HR/MIN/TUN DN and HR/MIN/TUN-UP 16. SELECT 17. EQ (Equalizer) 19. VOLUME / 18. PLAYLIST +/20.
2. Insert a 3V lithium battery (CR2025 or equivalent) with the polarity (+) matching the indication inside the battery compartment. 3. Close the battery compartment. Note: The remote control battery normally lasts for about one year, although it depends on how often and for what operations the remote control is used. If the remote control fails to work even when it is operated near the unit, replace the battery. Precautions when using batteries 1.
9. To disable the alarm function, press the ALARM SET 1/2 button. Note: • While the buzzer alarm volume is fixed and cannot be adjusted, the music alarm volume can be adjusted to your desired level usingthe VOLUME +/- button. • If iPod mode is selected, make sure the iPod is inserted in the docking station and the volume is set to a suitable level. • This unit has a dual alarm function. Use the ALARM SET 1 button to set the time for alarm 1, or the ALARM SET 2 button to set the time for alarm 2.
DIMMER control Slide the DIMMER switch to HI (high) or LO (low) to adjust the brightness of the LCD display. DISPLAY function In radio mode, press the DISPLAY button to display the clock time. Press it again to return to the radio information display. RESET function Press and hold down the RESET button for 5 seconds to reset the unit. RADIO OPERATION Listening to the radio 1. When the unit is switched on, press the FUNCTION button to select radio mode. 2.
2. Insert the adapter into the docking station at the top of the unit with the two tabs facing forwards . 3. To remove the adapter, press the back of the adapter and pull it up.
REPEAT playback Press the REPEAT button on the remote control several times to select repeat playback mode. Press it once to repeat the current track. Press it twice to repeat all the tracks from an album or playlist. Press it a third time to cancel the repeat function. RANDOM playback Press the SHUFFLE button on the remote control to play the tracks in random order. Press it again to cancel the function.
TROUBLE-SHOOTING GUIDE Problems 1. The player or display does not work properly. 2. No sound, poor sound. 3. Noise or distorted sound in radio mode. 4. No sound, poor sound in iPod mode. Recommendations 1.1 Press the STANDBY button to go to standby mode and press it again to turn on the unit. 1.2 Press and hold down the RESET button for 5 seconds to reset the unit. 1.3 Reset the unit by unplugging the AC power cord for a few seconds, then plug it back in. 2.1 Check the cable connections. 2.
