Instruction manual

GB 5
PROGRAMMED PLAYBACK
MP3 / WMA / USB
display
" PROGRAM "
CLEANING THE UNIT
Donotusevolatilechemicalsonthisunit.Cleanbylightly
wipingwithasoftcloth.
IMPORTANT NOTE
Ifanabnormaldisplayindicationoranoperatingproblem
occurs, disconnect the AC power cord and remove the
batteries. Wait at least 5 seconds, then reconnect the AC
power cord or reinstall the batteries.
WARNING
ShouldtheCDdoorbeopenedbeforethereadingoftheCD
iscompleted,ajammingnoisemayoccur.Thisisresolved
byclosingtheCDdoor.
CLEANING CD
IftheCDskipsorwillnotplay,thediscmayneedcleaning
.Beforeplaying,wipethediscfromthecentreoutwitha
cleaningcloth.Afterplaying,storethediscinitscase.
MAINTENANCE
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the
brush.Fingerprintsmayberemoved with acottonswab
moistened with alcohol.
PROGRAMMED PLAYBACK
FOR NORMAL COMPACT DISC PLAYBACK
Programmedplaybackenablestracksonadisctobeplayed
inthedesiredorder.Upto20trackscanbeprogrammed.
1. Press the " PROGRAM " button.
2. Press the " NEXT " and " BACK " buttons to select
the desired track number.
3. Press"PROGRAM"buttonagaintomemorizethe
track.
4. Repeat steps 2 and 3 until all desired tracks are
 programmed.
5. Press the " PLAY/PAUSE " button to start.
" PLAY " & " PROG. " are shown on the
CD display.
6. Press"STOP"buttontostopprogrammed
playback.
7. Press " PROGRAM " and " PLAY/PAUSE " buttons
 toresumeprogrammedplayback.
8. Open the CD door or turn off the CD player to clear
 theprogrammedmemory.
Note : Programmingcanonlybemadewhentheplayer
is in stop mode.
FOR MP3 / WMA / USB PLAYBACK
Programmedplaybackenablesfolders/albumsortracksona
disc to be played in the desired order. Up to 20 folders/albums
ortrackscanbeprogrammed.
1. Press the “PROGRAM” button.
2. Press the “FOLDER UP” buttons to select the desired
folder number.
3a. For‘Folderprogramming’,press“PROGRAM”button
 againtomemorizethefolder.
b. For‘Trackprogramming’,pressthe“NEXT”and
“BACK” buttons to select the desired track number.
 Then,press‘PROGRAM”buttonagaintomemorize
the selected track.
4. Repeat steps 2 and 3 until all desired folders or
 tracksareprogrammed.
5. Press the “PLAY/PAUSE” button to start. “PLAY “,
“PROG.” and “MP3” / "WMA / USB" are shown
on the CD display.
6. Press“STOP”buttononcetostopprogrammed
playback.
7. Press“PLAY/PAUSE”buttontoresumeprogrammed
playback.
8. Open the CD door, turn off the CD player or press
 “STOP”buttontwicetocleartheprogrammed
memory.
Note: Programmingcanonlybemadewhentheplayer
is in stop mode.
CD display
" PROGRAM "
CD48USB SCOTT FM ONLY-ENG-TCD12N7 7 13/5/2009 11:09:55