User manual

45
Setting up the eyesite 550
Connecting a Device to the Interface connection on the eyesite 550
IMPORTANT NOTE: Please read these instructions before attempting to connect any
device to the eyesite 550 Interface connector.
.
Alarm Input
Connect the alarm input to the sensor wires on the RJ-45 connector labeled
“Interface” on the eyesite 550
The sensor input can be a voltage source between 0 and 25 VDC, or a volt free
contact, and should be connected between pins 5(-) and 6(+) (alarm in) of the RJ-45
connection.