User manual

Connecting a Monitor

Connecting the eyesite 550 to a Monitor enables you to see the video picture on the

TV screen and hear the sound from the Monitor’s loudspeaker.

To connect a monitor to the eyesite 550:

1. Connect the yellow video out connector to the video in connector on your

monitor using the supplied dual phono leads.

2. Connect the red audio out connector to the ‘audio in’ connector on your

monitor.

Connecting Cameras

To connect cameras to the eyesite 550:

• You need a BNC cable.

• Read any instructions provided with your camera before connecting to the eyesite

550.

1. Connect the video output from the camera to Video In on the eyesite 550

system.

2. If the camera has a built-in microphone that you want to use, connect the

camera’s audio output to your eyesite’s Interface connector using the

appropriate RJ-45 breakout module ensuring that the microphone has the

correct amplification to provide a line level audio output (1Vp-p).

3. Press the MENU button to access the Setup Menu.

4. Press the number 3 key to access the Camera Video Setup menu, then press the

number 1 key to enter preview mode. Press the appropriate number (1-6) to

check the camera image.

5. Press the EXIT button to leave preview mode.

To connect a pan/tilt/zoom camera:

•Use the Video In A/V connection and use a Data Port on the back of your

remote video system to connect the camera control PTZ cable. Follow the

instructions provided with your camera.

Configure the Data Port Options:

1. Press the MENU button on the eyesite 550 system to access the Setup Menu.