User manual

76
Using the Supervisor PIN Mode During a Call
You can change the Far End preset if the following are true:
• The unit being called has Supervisor Mode turned ON.
• The unit being called has Remote Access turned ON.
• The correct Supervisor PIN is entered.
To set up video presets on a remote remote video system:
1. Press the MENU button on the remote control, then press the START button
twice. The Manual Dial screen is displayed.
2. Use the number keys to enter the IP address in the Addr field of the party you
wish to call.
3. Use the Down arrow key to highlight the PIN field. Use the number keys to
enter the four digit Supervisor PIN.
4. Press the START button to dial your call.
5. When the call is connected, press the FAR key. The transparent arrow facing
away from you indicates FAR end camera control. The transparent S at the
bottom left corner of the screen indicates Supervisor Mode.
6. Press a number key between 1 and 6 to select the video source you wish to
view.
7. Use the Zoom In and Zoom Out buttons along with the arrow keys to pan/tilt/
zoom the view you wish to save.
8. Press the PRESET key twice followed by a number key, to save your preset.
9. Repeat steps 7 to 9 as necessary.