User`s manual

Chapter 5 - Interacting with the Blazer PRO
23
Powering the Blazer PRO ON and OFF
Always Power On and Off as stated below. Your printer requires a proper startup and shutdown cycle that
may only run if the following steps are followed correctly.
Powering On
Power On the Main Power Switch1.
Place the Main Power Switch (located adjacent the AC cord) to
the up position.
2. Power On the User Interface
Five seconds after the main power is turned on, on the
virtual LED on the User Interface, labeled “Automatic
Mode” becomes
Red. When it becomes Red, it means
that it is ready to be powered up.
Always wait for the virtual dial to become Red, then
press the
Orange Power On button on the User
Interface.
The Blazer PRO will go through a normal startup cycle that
will take a few minutes. When the printer has nished starting
up, it will be in Print status or Paper Out ROLL/Cut Mode on
the LCD Display. Do not attempt any further procedures until
the startup cycle is complete.
Powering Off
Power Off the User Interface1.
Press the Power Off button (Red) on the User Interface.
Power Off the Main Power Switch
2.
Place the Main Power Switch (located adjacent the AC cord) to the down position.
When powering OFF, your printer goes through a shut down cycle that seats the head onto the Capping
Station to help prevent Print Head clogs. DO NOT turn off the unit at the power strip. It WILL NOT go
through a normal shut down.
Main Power Switch
The virtual LED turns red after 5 seconds