User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
52
In the Auto Adjustment section of the Media 5.
Adjustment window, select Bi-Directional or
Uni-Directional Alignment from the drop down
menu (depending on what alignment you want
to complete). If you want to print in High Speed
Print Modes (Bi-Directional), you will want to
complete the Alignment process for both Uni and
Bi-Directional. Some of our users have had success
completing only the Bi-Directional Alignment.
NOTE: DO NOT select any of the Auto Alignment
options (in blue) on this screen.
IMPORTANT NOTE: If you
are performing this procedure as
part of your printer’s Initial Setup or if you notice a severe registration issue, we
recommend you perform the Uni-Directional Alignment rst, followed by a Bi-
Directional Alignment. If you only wish to ne tune printer output, you can utilize
the Bi-Directional Alignment as a standalone procedure.
6. Within the Bi-Directional or Uni-Directional Alignment screens, place a check mark in the rst of the
three boxes ONLY, below Dot Size. (You will have to repeat this process two ADDITIONAL times,
placing check marks in Dot Size 2 the second time and Dot Size 3 the third time.) Select Other for
Media Type, enter 2 for Paper Thickness and select Standard from the Platen Gap drop-down menu.
DO NOT modify
any of the numbers
in the boxes yet.