User`s manual
Lubricating the two Main Rails will
prevent oxidation (rust) and debris build-
up, allowing the Printer Assembly to travel
freely. This will help prevent registration
issues that can occur in multiple pass
prints.
To correctly lubricate the Main Rails, apply a very THIN coat of the 2.
same Lithium-based grease used for the Rail Guides. Spread the White
Grease along the ENTIRE length of both Rails using a clean, lint-free
cloth. DO NOT use any other lubricate, such as WD-40 or Machine Oil,
or you risk contamination of the Rail Guides.
Do Not Lubricate the Drive Screw
The Drive Screw MUST NEVER be lubricated or wiped off with a chemical solvent.
This is due to a special coating that has already been placed on the Drive Screw
topreventdustbuildupthatcouldpotentiallyhindertheuidmovementofthe
Printer Assembly. Treating the Drive Screw will allow dust buildup, contaminating
the drive mechanism.
Drive Screw
Chapter 10- Preventative Maintenance
and Problem Solving
93
Main Rail- One per side
Two in Total