User's Manual

ISO 9001:2000 Cert. N°4500/1
Version 1.1 SDT_ARK6_User_Manual_ENG_vATSC Page 118 of 206
Description-Event
Event Description
PS Restart N
This event is reported when one of the following alarms is raised:
 PS1/2 50V voltage out range
 PS1/2 50V current out of range
The fourth time one of the preceding alarms is raised the amplifier is
restarted (from 1 up to 4 times).
N: number of amplifier restarting.
Only in SDTX 201 and 501 versions.
PS OFF
After the fourth time the amplifier has been restarted, if an alarm
condition causing a PS Restart event occurs, PS OFF event is
reported and the amplifier is turned off
When this event is reported amplifier can be turned on only by OPTO
2 or by the Restart button in the Output window (only in SDTX 201
and 501 versions).
Restart Amp. from OPTO
This event is reported when the retry command is given by the Retry
Alarm OPTO (OPTO 2).
PS ON
This event is reported at every amplifier restarting
Events List cleared
This event is reported when the events list is cleared.
Updating string fw...
This event is reported when the update of the FPGA firmware starts.
String values:
 "ISDBT",
 "ITU",
 "DVB-T",
 "ATSC",
 "DVB-T2",
 "ECHO",
 "Rep. Analog",
 "Rep. Digital".
FPGA firmware err xx
This event is reported when an error occurs during the update of the
FPGA firmware.
xx: error code:
 0x10, 0x20, 0x01, 0x02, 0x03: programming error;
 0x11: firmware not found in FS (for the current mode);
 0x22: FPGA file opening error;
 0x33: FPGA file reading error;
 0x44: erasing FLASH memory block error.
FPGA firmware OK
New FPGA firmware successfully loaded.
Saving config…
Saving configuration task started (after the command “s” given by
RS232 or GbE commands).
Save config Finished
Saving configuration task correctly ended.
Save config error: xx
An error occurs during saving configuration.
xx: error code:
 0x80: File system busy;
 0x01: New *.sav file opening error;
 0x02: uC header writing error;
 0x03: uC data writing error;
 0x04: FPGA header writing error;
 0x05: FPGA data writing error;
 0x07: File date writing error;
 0x08: Old *.sav file deleting error
 0x09: New file naming error (deleting of “*”);
 0x0A: File date writing error it can’t be found into the FS
 0x10: file already opened.
Pwr adjusted to xx.x dBm
New output power setting due to a set value exceeding the mode
specific power range.
xx.x: output power expressed in dBm.