User's Manual

ISO 9001:2000 Cert. N°4500/1
Version 1.1 SDT_ARK6_User_Manual_ENG_vATSC Page 29 of 206
5.2 Java Menu Bar
The following figure shows the menu bar of the Java Graphic User Interface. It allows the switching
between control pages that will be described in detail in next chapters.
Figure 5. Java menu bar
The following controls are provided:
System commands bar allows to enable of the following commands:
 Connect: releases/acquires the connection to the device.
 Save: saves the device configuration.
 Load: loads the last saved configuration.
Figure 6. System commands bar
Operation pages bar allows to switch between the following windows:
 Home Page: shows the firmware updating status, allows to reset the device, to locally
download the *.jar file, to enable the Stand-by mode and to switch between operative modes.
 Input: shows ASI, GbE and Tuner input statistics.
 Tuner: allows to monitor input channel, frequency offset, signal level and quality and to
monitor the Front-End demodulation parameters.
 ITU: allows to monitor and to set the ITU specific parameters.
 ISDB-T: allows to monitor and to set the ISDB-T specific parameters.
 DVB-T: allows to monitor and to set the DVB-T specific parameters.
 ATSC: allows to monitor and to set the ATSC specific parameters.
 DVB-T2: allows to monitor and to set the DVB-T2 specific parameters.
 Mod. Pha.: allows to manage the linear compensation curves.
 AM PM: allows to manage the non-linear compensation curves.
 Adaptive Linear Precorrection: allows to manage the adaptive linear compensation.
 Adaptive Non Linear Precorrection: allows to manage the adaptive non linear compensation.
 Outputs: allows to set clock and output parameters and to monitor the hardware status.