ASTRA 300RS REMOTE START WITH KEYLESS ENTRY AUTOMATIC TRANSMISSION ONLY PRODUCT MANUAL
Limited Lifetime Warranty This vehicle Remote Start system is warranted to the original purchaser, to be free from defects in material and workmanship. The manufacturer will repair or replace at its option, and free of charge for the first twelve (12) months, any part that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to the manufacturer freight prepaid.
Remote Transmitters Remote Transmitter Description LED Button 1 Button 2 Button 3 Button 4 The Astra 300 is supplied with two 4-button Remote Transmitters used to control system operations. Button 1 Locks the doors and when held for 2 seconds, activates the system’s Panic feature. Button 1 also locks the doors when the system is in Valet Mode. Button 2 Unlocks the doors. . Button 2 also unlocks the doors when the system is in Valet Mode. Button 3 Activates the Auxiliary 1 output.
System Operation 300RS Adding/Replacing One-Way Transmitters To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired transmitters ready and follow the steps below. Note: Up to 4 transmitters can be programmed to operate the system. To erase any previously stored transmitter codes, be sure to program all 4 transmitter memory locations. To program the transmitter(s): 1. Turn on the ignition key On, Off, On, Off, and back On. · The Horn will flash 3 times.
Remote Starting System Operation 300RS To Remote Start the System: 1. Be sure the system is not in Valet Mode. 2. Press Button 1 on the remote for two seconds. · The parking lights will flash 4 times and turn on. · The Horn will chirp 4 times when starter confirmation chirps is enabled. · The engine will start and run for the duration of its programmed Run Time.* · The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
System Installation 1. Thoroughly read and become familiar with the installation instructions before beginning the installation. 2. Review system contents: Main Unit Two 4-Button Remote Transmitters Harnesses • 6-Wire starter harness • 3-Pin Power harness • 8-Pin main harness • 3-Pin door lock harness • LED, Valet Switch and antenna Harness 3. Verify vehicle is equipped with electronic fuel injection, and starts/idles normally before installation. 4.
6-Wire Starter Harness System Wiring Pin 1 RED - A: Main Power Input A (+). Connect to the battery or constant power wire at the ignition switch with a minimum 30 Amp supply. Remove the fuse until the installation is complete and all wiring is checked. Pin 2 RED - B: Main Power Input B (+). Connect to the battery or constant power wire at the ignition switch with a minimum 30 Amp supply. Pin 3 BROWN: Second Ignition Output (+). The Brown wire provides +12V for a second ignition wire.
System Programming System Programming The system programming is compatible with both the LCD transmitter or the standard AM transmitter. Enter System Programming: 1. Turn on ignition. 2. Within 5 seconds, press the valet switch 5 times. · The horn will provide three chirps, indicating that you have entered Programming. 3. Press the valet switch the number times equal to the System Parameter you want to change. · The horn will chirp each time the valet switch is pressed. 4.
System Programming 12. Auxiliary 1 Mode. Selects from momentary, 10 second timed, or latched operation for Auxiliary 1. Momentary operation provides an output for as long as the transmitter button is pressed. Timed operation provides an output that turns on for 10 seconds each time the transmitter button is pressed. If the button is pressed again during the 30 seconds, the output will turn off.
System Programming Brunch Feature 2 NA 1 NA Button 1 Button 2 Button 3 Silent Horn Chirps ON Reset Mobilink 3 Lock/Unlock Chirps 5 Extended Parking Lights On Off 7 Ignition Door Unlocking On Off 4 6 8 9 10 11 NA Ignition Door Locking Door Unlock Pulse Door Lock Pulse Length N.A N.
Door Lock Diagrams Negative Trigger Reverse Polarity Positive Trigger/ additional 2 relays reqiured Adding Actuators Astra 300RS - Page 11
Wiring Diagram Brown - Ignition-2 (+) Yellow - Ignition -1 (+) Orange - Accessory (+) Violet - Starter Out (+) Red - Battery 1 (+) Red - Battery 2 (+) Starter Harness Red - +12v In (+) White - Parking Light Out (+/-) Black - Ground in (-) Power Astra 300RS White/Violet - Factroy Disarm Out (-) Blue/Orange - Ground When Running Out (-) Brown/White - Horn Out (-) Gray - Trunk - Release Out (-) White/Black - Hood Trigger In (-) Green/White - Brake Light In (+) Black/Gray - RPM In Orange - Starter Disable