User's Manual

SD GlucoNavii® Voice N BLOOD GLUCOSE MONITORING SYSTEM
Control solution display
32
STEP-1:
1) Remove a new test strip from container. Be sure to
tightly replace container cap after removing test strip.
2) Insert a test strip (yellow window printed ‘ ’ facing
up) into test strip slot. The meter turns on automatically.
STEP-2:
1) Press the left button for 3 seconds to check the testing
system using a control solution in Blood Stand-by
Display. If you don’t want a control solution test, press
the left button again.
2) Shake the control solution container and discard the
rst drop of solution. Gently squeeze the container
to form one small drop. Bring the drop to the edge of
the strip, and allow the strip to automatically draw the
control solution into the yellow window. When control
solution is applied to the test strip, the meter counts
down from 5 to 1 second on the display. Tightly replace
the cap on control solution.
VOICE N
[Left button]