User's Manual

Press the time set button to confirm year. The date will flash.
Press the or button to set the date (hold for rapid
adjust).
Press the time set button. 2 beeps will confirm Clock Setting
is complete.
Note: Make sure that the Year, Month, and Date settings are
correct so that the Auto Daylight Savings Time adjustments
will occur on time.
When Low Battery Icon flashes on the right of the display,
replace backup batteries with 2 fresh AA batteries. Keep unit
connected to AC power when replacing batteries or you will
lose settings. Make sure to match polarity (+/–) on batteries
as shown below.
Battery Cautions an d Tips
• Only use the recommended/supplied batteries or equivalent.
• Use alkaline batteries for longer life.
• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or
rechargeable nickel-cadmium batteries.
• Insert batteries with proper polarity (+/–) as indicated.
• Remove exhausted batteries from product.
• Do not attempt to recharge non-rechargeable batteries.
• Do not open batteries or heat them beyond normal ambient temperatures.
• To prevent battery leakage or damage remove batteries from a product if it
will not be used for a month or longer.
• Use extreme caution handling leaking batteries (avoid direct contact with
eyes and skin). If battery leakage comes in contact with eyes, IMMEDIATELY
flush the eye with lukewarm and gently flowing water for at least 30 minutes.
If skin contact occurs, wash skin with clear water for at least 15 minutes. Seek
medical attention if any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous or combustible
material.
• Do not dispose of batteries in the household trash or fire.
• Follow applicable laws and local regulations for the disposal and
transportation of batteries.
Once sta has completed
setup, adjust cable on AC
adapter to fit under the cable
housing on the security cover
on back of unit and tighten
thumbscrew.
• Place the unit on a level surface away from sources of direct
sunlight or excessive heat.
• Clean your unit with a soft, damp cloth. Strong cleaning agents,
such as thinner or similar materials can damage the surface of the
unit.
Secure the attached Security Tether to a wall or
other permanent surface.
CAUTION: DO NOT attach to an AC outlet or
cause it to become entangled with anything
that can create a hazardous situation.
Bluetooth Pairing
1. Press and hold the Bluetooth Button. Unit will enter
pairing mode.
2. Select “HBH36” on your device’s Bluetooth menu.
Manual Clock Setting
Press and hold the time set button on the back of the unit to
enter clock setting mode. The time will flash and CLOCK SET
will appear on the display.
Press the or button to adjust time (hold for rapid
adjust). Make sure to set the correct AM or PM time.
Press the time set button to confirm time. The year will
flash.
Press the or button to set the year.
HBH36
Sta Quick Start Guide
Included
• HBH36 system
• Universal AC adaptor
Set Up
HBG36QSG-171110-A © 2018 HTI Industries, LLC. All rights reserved Printed in China
Remove thumbscrew and
remove back security cover to
access sta controls (volume
limit switch, DST switch, time
set button, time zone button),
and DC jack.
Connect the universal voltage
AC adapter to the wall outlet
and the DC jack on the back
panel of the unit.
Charging Devices
Connect USB cable
(not included) to
USB port and the
other end to your
device to charge.
Setting the Time Zone and Clock
(Factory Preset Clock)
The first time you connect your new preset clock to the AC
outlet, the unit will automatically show the correct Eastern
Standard time, which is the default setting. If you are not in
the Eastern time zone, you must change the default setting to
match your time zone (see Time Zone Setting below). Once
the correct time zone is set, if the time displayed is not
correct, follow steps under Manual Clock Setting to set the
correct hour, minute, year and date.
Time Zone Setting
Press and hold the time zone button. The default EASTERN
time zone will flash in the bottom of the display.
Press and release the time zone button to confirm time zone
setting.
Daylight Saving Time
The unit ships with the Daylight Saving Time (DST) switch in
Auto position, and will automatically adjust when the time
changes in March and November. To switch manually, slide
switch to +1 to add an hour or to -1 to subtract an hour.
Volume Limiter
The unit ships with the Volume Limit switch in OFF position,
and the maximum volume output will be at 100%. For smaller
rooms, slide the switch to the ON position to limit/lower the
maximum volume by 25%.
Press and release the or button as needed until your
time zone is displayed. The time display will also change.
TIP: Press the Alarm On/O Button when
display is flashing during clock setting to
toggle between 12 hour and 24 hour display
modes.
Battery backup installation
time set
√
time set
time set
outlet
time set
Cable on AC adapter
HBH36 Quick Start Guide - Inside
HBN36 Quick Start Guide (English) - Front
Size: 432 x 140 mm
Color: 1C + 1C (Black)
Material: 100 gsm WF paper
Date: Nov 10, 2017
Folded size: 108x 140(mm)
3. Press and release the or Volume Buttons to adjust speaker
volume.
USING THE SPEAKERPHONE
Press and release the Button to answer a call.
Press and hold to ignore or end a call.