HWL83 Staff Quick Start Guide Included • HWL83 system • Universal AC adaptor
Set Up Remove thumbscrew and remove back security cover to access staff controls (volume limit switch, DST switch, time set button, time zone button), and DC jack. Connect the universal voltage AC adapter to the wall outlet and the DC jack on the back panel of the unit. Charging Devices Connect USB cable (not included) to USB port and the other end to your device to charge.
Setting the Time Zone and Clock (Factory Preset Clock) The first time you connect your new preset clock to the AC outlet, the unit will automatically show the correct Eastern Standard time, which is the default setting. If you are not in the Eastern time zone, you must change the default setting to match your time zone (see Time Zone Setting below).
Press and release the time zone button to confirm time zone setting. time zone Daylight Saving Time The unit ships with the Daylight Saving Time (DST) switch in Auto position, and will automatically adjust when the time changes in March and November. To switch manually, slide switch to +1 to add an hour or to -1 to subtract an hour.
Manual Clock Setting Press and hold the time set button on the back of the unit to enter clock setting mode. The time will flash and CLOCK SET will appear on the display. time set Press the - or + button to adjust time (hold for rapid adjust). Make sure to set the correct AM or PM time. Press the time set button to confirm time. The year will flash. time set Press the - or + button to set the year.
Press the time set button to confirm year. The date will flash. time set Press the - or + button to set the date (hold for rapid adjust). Press the time set button. 2 beeps will confirm Clock Setting is complete. time set √ Note: Make sure that the Year, Month, and Date settings are correct so that the Auto Daylight Savings Time adjustments will occur on time. TIP: Press the Alarm On/Off Button when display is flashing during clock setting to toggle between 12 hour and 24 hour display modes.
When Low Battery Icon flashes on the right of the display, replace backup batteries with 2 fresh AA batteries. Keep unit connected to AC power when replacing batteries or you will lose settings. Make sure to match polarity (+/–) on batteries as shown below. This device complies with Part 15 of the Rules.
Once staff has completed setup, adjust cable on AC adapter to fit under the cable housing on the security cover on back of unit and tighten thumbscrew. Cable on AC adapter ay s • Place the unit on a level surface away from sources of direct sunlight or excessive heat. • Clean your unit with a soft, damp cloth. Strong cleaning agents, such as thinner or similar materials can damage the surface of the unit. Secure the attached Security Tether to a wall or other permanent surface.
Folded size: 108x 140(mm) HWL83 Quick Start Guide (English) - Front Size: 432 x 140 mm Color: 1C + 1C (Black) Material: 100 gsm WF paper Date: Feb 01, 2015 Set Up HWL83 Staff Quick Start Guide Included • HWL83 system Setting the Time Zone and Clock (Factory Preset Clock) Remove thumbscrew and remove back security cover to access staff controls (volume limit switch, DST switch, time set button, time zone button), and DC jack.
HWL83 Legal Sheet - Front Size: 108 x 140 mm Printing Color: Black Mat’l: 100 gsm WF paper Jan 08, 2016 1C + 1C IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference.
