User's Manual

Using the iBN18

P10

Setting and Using the Alarms

This unit has 2 separate alarms, each set the same way. Below we explain how to set Alarm 1.

To set alarm 2, follow the same steps using the Alarm 2 Button.

Note: each step must be completed while display is flashing or step will time-out with any changes saved.

1. Press and hold the Alarm 1 Button for 2 seconds until the time display and alarm icon flash, and a beep

sounds.

2. Press the – or + Buttons to adjust the alarm time to the desired time (hold for rapid setting).

Make sure you set the correct AM/PM alarm time. The AM and PM indicators appear on the left of the

display.

3. Press the Alarm 1 Button to confirm the alarm time setting. The wake-to source will flash.

4. Press the – or + Buttons to select the desired wake to alarm source: BT (Bluetooth) or TONE.

Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is detected, the

alarm will default to current Tone.

Wake to Tone: Press the Alarm 1 Button to confirm. Press the – or + Buttons to select one of the

four built-in wake-to tones.

5. Press the Alarm 1 Button to confirm the alarm source. The volume display will flash.

6. Press the or Buttons to adjust the alarm volume on the unit from 05 - 40. Note that the alarm volume

setting is stored separately from other volume settings.

7. Press the Alarm 1 Button to confirm the alarm settings and exit alarm setting mode. 2 beeps will confirm

clock setting is complete. The alarm icon will remain on the display, indicating the alarm is armed.