User's Manual

iBT18

Using the

Setting and Using the Alarms

This unit features dual alarms which can be set to different times and alarm sources. Each is set in the same

way. Instructions are given as “Alarm Button”; use Alarm 1 Button or Alarm 2 Button to set respective

alarms. Alarm will sound for 1 hour until reset

Note: each step must be completed while display is flashing or step will time-out with any changes saved.

Press and hold the Alarm Button for 2 seconds until the alarm time display and alarm icon flash.

Press the – or + Buttons to adjust the alarm time to the desired time (hold for rapid setting).

Make sure you set the correct AM/PM alarm time. The AM and PM indicators appear to the left of the

display.

3. Press the Alarm Button to confirm the alarm time setting. The alarm schedule will flash.

Press the – or + Buttons to set the alarm schedule (‘7 DAYS’ = the whole week, ‘5 DAYS’ = Monday

through Friday, ‘2 DAYS’ = Saturday and Sunday only).

5. Press the Alarm Button to confirm the alarm schedule setting. The wake-to source will flash.

6. Press the – or + Buttons to select the desired wake to alarm source: Bluetooth or tone. The selected

wake-up source will flash in the lower part of the display.

Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is detected, the

alarm will default to Tone.

Wake to Tone: Press the Alarm Button to confirm. Press the – or + Buttons as needed to listen to

and to select one of the four built-in wake-to tones (1 - 4).

7. Press the Alarm Button to confirm the alarm source. The volume display will flash.

(Continued on page 7)