User's Manual

Setting and Using the Alarms (Continued)

1. Press and hold the Alarm Button for 2 seconds until the alarm time display and alarm icon flash. A

beep sounds.

2. Press the or Buttons to adjust the alarm time to the desired time (hold for rapid setting).

Make sure you set the correct AM/PM alarm time. The AM and PM indicators appear to the left of

the display.

3. Press the Alarm Button to confirm the alarm time setting. The wake-to source will flash.

4. Press the or Buttons to select the desired wake to alarm source: Bluetooth, radio or buzzer.

Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is

detected, the alarm will default to buzzer.

Wake to Radio: Press the Alarm Button to confirm. Press the Presets Button to select an FM preset

to wake to, or press the or Buttons to tune in a desired wake to station.

Wake to Buzzer: You will wake to buzzer.

5. Press the Alarm Button to confirm the alarm settings and exit alarm setting mode. 2 beeps will confirm

alarm setting is complete. The alarm icon will remain on the display, indicating the alarm is armed.

6. To turn off a sounding alarm and reset it to come on the next day at the same time, press the

Power/Alarm Reset Button or the associated alarm button ( or ).

Previewing the Alarm and Turning the Alarm On/Off

Press and release the desired Alarm Button as needed to toggle the alarm ON (indicated by the alarm

icon) or OFF (no alarm icon).

Using the iBT230