User's Manual

Setting and Using the Alarms (Continued)

1. Press and hold the Alarm Button for 2 seconds until the alarm time display, alarm button

and alarm icon flash. A beep sounds.

2. Press the or Buttons to adjust the alarm time to the desired time (hold for rapid

setting). Make sure you set the correct AM/PM alarm time. The PM indicator appears to the

left of the display; there is no AM indicator.

3. Press the Alarm Button to confirm the alarm time setting. The alarm schedule will flash.

4. Press the or Buttons to cycle to the desired schedule: “7 d” (every day), “5 d” (week

days) or “2 d” (weekends).

5. Press the Alarm Button to confirm the alarm schedule setting. The wake-to source will

flash.

6. Press the or Buttons to select the desired wake to alarm source: Bluetooth, FM radio

or selected tone.

Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is

detected at wake time, the alarm will default to tone one (”t1”).

Wake to Radio: Press the Alarm Button to confirm. Press the Presets Button to select an

FM preset to wake to, or press the or Buttons to tune in a desired wake to station. (To

set Presets, see Setting and Using FM Presets on page 10.)

Wake to Tones: You will wake to the selected tone. Press the Alarm Button to confirm, then

press the or Buttons to preview and select a desired tone (t1 -t4).

7. Press the Alarm Button to confirm the wake to source. The alarm volume will flash.

8. Press the or Buttons to select the desired alarm volume.

9. Press the Alarm Button to complete alarm setting and exit alarm setting mode. 2 beeps will

confirm alarm setting is complete. The alarm icon will remain on the display, indicating the

alarm is armed.

8. To turn off a sounding alarm and reset it to come on the next day at the same time, press

the Power Button or the associated alarm button ( or ) to reset alarm.

Previewing the Alarm and Turning the Alarm On/Off

Press and release the desired Alarm Button as needed to preview current alarm time/ toggle the

alarm ON (indicated by the alarm icon and lit alarm button) or OFF (no alarm icon/alarm button

is not lit).

Using the iBT232