User's Manual

2
Page 5
iBT28 Quick Start
1: power
Press and hold the Time Set/Sleep Button until the
display flashes and a beep sounds.
Press – or + Button to set correct time (hold for rapid
adjustment). Make sure to set correct AM or PM time.
Press the Time Set/Sleep Button again, then press –
or + Button to set the correct year.
Press the Time Set/Sleep Button again, then press –
or + Button to set the correct date.
Press the Time Set/Sleep Button again to complete
time setting. 2 beeps will confirm time setting is done.
3: time set
Press and release the Color Button as needed to cycle
through color mode settings. In GLOW color change
mode, press and release the Color Button when a
specific color is showing to select that color.
When the unit is OFF and in 1 COLOR mode, press the
– or + Button to change color.
4: color change
Attach AC adaptor cable to the
DC adapter jack on back of the
iBT28 and plug the other end
into a wall socket. Remove the
tab from the battery backup
compartment.
Power on your Bluetooth audio device and turn on Bluetooth capability on your
device (Settings>Bluetooth on IOS). Press the Button on the unit to turn the unit
on. The first time the unit is powered on, it will enter Auto-pairing mode and attempt
to pair with an available Bluetooth device. “iHome iBT28” should appear on your
device’s list of Bluetooth devices. Select “iHome iBT28” on the device to complete
pairing (if prompted for a PIN/password, enter 1234. “PAIRED” should appear on
the display and 2 beeps will confirm pairing is complete. Press the Button to
play or pause audio.
2: Bluetooth pairing: first time use
If you experience any
trouble pairing your
device, see the Using
Bluetooth section of
this booklet on page 3.
RESET
RESET
TEST
TEST