User's Manual

This unit has a dual alarm system so you can set two separate alarms to different alarm times and sources.

Setting the Alarms

Note: Alarm 1 and Alarm 2 are set the same way; Alarm Button below means the button ( or ) for whichever alarm

you are setting.

1. Press and hold the or Button until the alarm time ﬂashes on the lower part of the display and a beep sounds.

Press and release the

– or + Button

to set the alarm time (press and hold for faster setting). Remember to set the

correct AM or PM time.

2. Press and release the Alarm Button again to conﬁrm the set alarm time. The wake to source will ﬂash.

3. Press and release the

Mode Button

as needed to set the alarm wake-to source: Bluetooth (BT), FM radio or Buzzer.

Waking to Bluetooth audio device: Make sure the unit is linked to a Bluetooth device, indicated by the Bluetooth

icon on the display. At the set alarm time the unit will send a play command to the currently linked Bluetooth device.

If the unit does not detect a linked Bluetooth device at the set alarm time, the unit will default to buzzer alarm. The alarm

cycle lasts for one hour; make sure you have enough music on your audio device to last that long.

Waking to FM radio: The default wake to source is the current FM radio station. Press and release the

– or + Button

to set a different station (press and hold to scan to the next clear station). To wake to a preset station, press the

FM presets Button to cycle to the desired preset (see page 5 for details on setting presets).

4. Press and release the Alarm Button again, then press and release

the – or + Button or the Color Button to

set the

color LED wake cycle: DAWN (amber fade leading up to alarm time), FLASH (ﬂashing red while alarm sounds), GLOW

(glowing color sequence while alarm sounds) or NONE (no wakeup LED effect).

5. Press and release the Alarm Button again (or no button within 10 seconds) to exit the alarm setting mode.

2 beeps will

conﬁrm alarm setting is

complete. The alarm will be armed once set and the corresponding alarm icon will light up. The

lower part of the display will show the earliest set alarm time.

Setting the Alarms

Page 7

Setting the Time

1. Press and hold the Time Set/Sleep Button. The time will ﬂash and a beep will sound. Press the – or + Button to set the

correct time (press and hold for rapid setting). Remember to set the correct AM or PM time. The AM and PM Indicators are

located to the left of the time digits.

2. Press the Time Set/Sleep Button again. The year will ﬂash. Press the – or + Button to set the correct year.

3. Press the Time Set/Sleep Button again. The date will ﬂash. Press the – or + Button to set the correct date (press and

hold for rapid setting).

4. Press the Time Set/Sleep Button again (or no button press within 10 seconds) to exit the clock setting mode. 2 beeps will

conﬁrm clock setting is complete.

Setting 12 or 24 Hour Time Display

1. Press and hold the Time Set/Sleep Button. The time will ﬂash and a beep will sound.

2. Press either the or Button to toggle the display between 24 hour (military) and 12 hour (standard) display mode. The

AM/PM indicators will not appear when display is in 24 hour mode.

3. Allow unit to “time out” (no button pressed within 10 seconds) to exit the clock display/time setting mode.