User's Manual

iBT30
Using the
3
P6
Setting Up the Unit: Charging
1. Connect the included AC adaptor to the DC jack
located on the back of the charging base and connect
the other end to a working wall outlet. Place unit on
charging base. For first time use, leave unit on
charging base until fully charged (about 8 hours). You
can operate the unit while it is charging. The status
indicator on the front of the unit will flash red when the
unit needs charging and glow steadily red while it is
charging. Once the unit is charged, the red status light
does not appear.
Turning the Unit ON and OFF
1. Slide the Power Off/On Switch located on the back of
the unit to the on position (right) to turn the unit ON.
The status indicator on the front of the unit will glow
blue.
2. To save power when operating on the internal battery,
press the Power Button located on top of the unit to
enter standby, or “green mode”, which uses less
power, but still allows normal operation. The status
indicator on the front of the unit will turn off. Note that
if no audio is detected within 3 minutes when power is
on, the unit automatically reverts to green mode.
3. Slide the Power Off/On Switch to the off position (left)
to turn the unit OFF.
12V
outlet
charging base