Model: iBT76 Color Changing Rechargeable Bluetooth Speaker with Speakerphone CHARGE BEFORE USE instruction manual
iBT76 Introduction Thank you for purchasing the iHome iBT76. This product is designed to provide high quality wireless sound for your iPad, iPhone, iPod, computer, PDA or other Bluetooth audio device. This instruction booklet explains the basic operation and care of the unit. Please read it carefully and keep for future reference. Maintenance • Place the unit on a level surface away from sources of direct sunlight or excessive heat.
iBT76 What’s Included • iBT76 speaker • Combination micro USB to USB charging cable/audio in cable • Carry strap iBT76 Combination micro USB to USB cable/audio cable Carry strap 2
iBT76 Meet Your iBT76 Front Top Microphone Charging/Bluetooth Status Indicator Light Bottom Carry Strap Channel (lantern mode) Power On/Off Switch Back Carry Strap Channel Bluetooth/ Speakerphone Button Color Mode Button (press and hold for Battery Review) Charging/ Aux-in USB port Lower/Raise Volume Buttons 3
iBT76 Getting Started: Carry Strap The iBT76 has two channels to attach the included carry strap, one on the bottom to hang the unit like a lantern, and one on the lower back of the unit. To attach the carry strap, form a small loop in one end of the carry strap. Insert this loop through the desired channel, then pull the loop back through the larger loop formed in the carry strap to tighten. OR Charging the Unit CHARGE UNIT BEFORE USE/KEEP UNIT OFF FOR FASTER CHARGING 1.
iBT76 3. To review the charging status of the unit while it is charging, press and hold the Color Mode Button. The cabinet lights will flash green from bottom to top for 12 seconds to show unit is charging. Reviewing Battery Charge Level (Charger is Disconnected and unit is ON) 1. Press and hold the Color Mode Button when unit is ON but not charging (micro USB cable not connected) to enter Battery Review Mode. The cabinet lights will blink and built-in voice will announce the current battery level.
Using the iBT76 Pairing Your Device Pairing is the set-up process to introduce your Bluetooth-capable device to the iBT76. Once your device is paired, the iBT76 can recognize it and you can play your audio through it. off on iHome iBT76 1. Turn on your Bluetooth device and make it “discoverable” by turning on Bluetooth mode (check in Options or Settings). 2. Slide the Power On/Off Switch to ON to turn on the iBT76.
Using the iBT76 Playing Audio Via Bluetooth 1. Slide the Power On/Off Switch to ON to turn on the unit. The Bluetooth status indicator will glow solid blue when a linked device is in range and detected. You can then listen to audio streamed wirelessly from your paired Bluetooth device. 2. Use controls on your Bluetooth device to play, pause and navigate tracks. 3. Press the – or + Button to adjust the iBT76 volume. You can also adjust volume on your device. 4.
Using the iBT76 Playing Audio via Aux In 1. Connect micro USB charging/audio cable to the Charging/Aux-in USB Port on the side of the unit and connect the 3.5mm audio plug end to the headphone or line-out jack on your audio device. 2. Slide the Power On/Off Switch to ON to turn the unit ON. 3. Power on the audio device and use the controls on the device to play or pause audio and to navigate tracks. 4. Press the – or + Button to adjust the system volume. You can also adjust volume on your device. 5.
Troubleshooting Unit doesn’t respond (no power) • • • • Make sure unit is completely charged. Check that all connections are correct and properly plugged in. Make sure your device is properly paired with the iBT76. Make sure the unit is on Unit doesn’t respond (locked up/ “frozen”) If the unit does not respond, try resetting the unit. Press and hold both the + and – Buttons at the same time for about 10 seconds. Note that doing so will clear settings, and any Bluetooth devices will need to be re-paired.
Internal Rechargeable Lithium-ion Battery This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it several times. If the battery does not recharge, please contact Customer Service at -1-800-288-2792. WARNING/DISPOSAL OF UNIT Please do NOT attempt to change the battery yourself. Doing so may damage the unit and will void the warranty.
FCC Information FCC Radiation Exposure Statement iBT76 FCC ID:EMOIBT80 IC:986B-IBT80 This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Consumer Product Safety Guide IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
L I M I T E D 1 Y E A R WA R R A N T Y iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.
