Model: iP44 (US English version) Print color : Black text on white paper Size of manual: 178mmW x 178mmH Date: June 24, 2010 P1 Model iP44 Pillow Shaker FM Alarm Clock Radio for iPhone or iPod Questions? Visit www.ihomeaudio.
P2 Table Tableof of Contents Contents iP44 Quick Start 1 Controls and Indicators 2-3 iP44 Display 3 Installing/Replacing the Clock Backup Battery 4 Getting Started 5 Setting Up the iP44 5 Using the Alarm 6 Charging your iPhone/Pod 7 Listening to iPhone/iPod 7 Listening to FM Radio 7 Sleep Operation 8 Using the iP44 in Other Countries 8 Dimmer Operation 8 A Consumer Guide to Product Safety 9 Trouble Shooting 10 Warranty Information 11 Maintenance • Place the unit on a level s
P3 FCC Information This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area.
P4 iP44 Quick Start 1:power 2:inserts 3:iPod/iPhone RESET R ESET TEST T EST Attach AC adaptor cable to jack on back of the iP44 and plug the other end into a wall socket. Select the dock insert for your iPhone/iPod model from the table below and place insert in dock. Never dock an iPhone or iPod without an insert in place. Insert iPhone or iPod into dock with proper insert (iPhone/iPod must not be in a skin or case). iPhone/iPod will charge while docked.
P5 Controls and Indicators Top Panel Reverse Button iPod / iPhone Dock Forward Button Play/Pause Button Radio/Aux Button Power On/Off/ Alarm Reset Button radio / aux. alm.
P6 Controls and Indicators Pillow Shaker On/OFF Switch Line-in Plug Snooze Button iP44 Display PM Indicator Time Display Buzzer Indicator Wake-to Indicator Radio Indicator Alarm Indicator iPhone/iPod Indicator Aux (pillow shaker) Indicator Battery Low Indicator Sleep Indicator 3 EXB Indicator
P7 Installing/Replacing the Clock Backup Battery The iP44 requires a CR2032 lithium battery (included) to provide backup power to the clock in the event of a temporary power interruption. The CR2032 backup battery was packed in the same poly bag with this instruction manual. 1. Place the clock radio face down on a flat surface. 2. Slide the battery door in the direction of the arrow and then lift the door by the opposite edge to remove it from the radio. 3.
P8 Getting Started Thank you for purchasing the iP44. Designed specifically to work with your iPhone and iPod, this system provides high quality audio performance that brings out the best in your music and lets you wake or sleep to it. Please read this instruction carefully before the appliance is operated and keep it for future reference. Install iPhone/iPod Insert Your iP44 comes with a set of inserts to ensure your iPhone or iPod fits properly in the dock on the top of the system.
P9 Using the Alarm Using the Pillow Shaker The iP44 comes with a pillow shaker that plugs into the aux wake-to (pillow shaker) jack on the back of the unit. You can wake to any alarm mode with or without the shaker. For example, if your alarm source is set to iPod and the pillow shaker is connected and on, the iPod will play AND the pillow shaker will vibrate at the set alarm time. 1. Connect the pillow shaker to the aux wake-to (pillow shaker) jack found on the rear of the unit. 2.
P10 Charging your iPhone/Pod Note: Please make sure you are using the correct insert for your iPhone/iPod and that it is properly docked into the iP44. Failure to do so may damage your iPhone/iPod. This unit does not charge non-docking iPod models. 1. While your iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Listening to iPhone/iPod 1. 2. 3. 4. 5. 6. 7.
P11 Sleep Operation Sleep mode lets you sleep to your iPhone/Pod or radio, gradually lowering the volume until the unit shuts off at the selected time. iP44’s sleep volume setting is independent of the normal volume level. You may adjust the sleep-to music volume to a softer level without affecting the main volume level that you will hear when the alarm turns on. 1. Press the Sleep Button to enter sleep mode. The sleep icon will show in the lower part of the display. 2.
P12 A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to assure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use. Keep these instructions handy for future reference. Take special note, and adhere to all warnings on the unit and in the instruction and service manual. 1.
P13 Trouble Shooting Symptom Unit does not respond (no power) iPhone/iPod does not dock properly iPhone/iPod does not respond to the unit iPhone/iPod didn’t charge up Possible Problem Solution AC adaptor isn’t plugged to a wall outlet or the connector is not plugged into the power supply jack on the back of the unit Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit Wall outlet is not functioning Plug another device into the same outlet to confirm the ou
P14 Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.
P16 iP44-072310-A Printed in China
