User's Manual

This unit features 3 video out jacks on the back of the unit to output

component or composite video from a docked iPhone or iPod.

Please see below to determine which video mode(s) your device

supports. Video cables are not included

• Composite (interlaced) - all iPod/iPhone models, 5G iPod ONLY

supports this mode

• Component (interlaced) - 1G iPod touch, iPhone

• Component (progressive) - iPod classic, 3G iPod nano, 4G iPod

nano, 2G iPod touch

The default video setting is Component.

• To switch into Composite Video Mode, hold down iPod Button and press Button.

• To switch back into Component Video Mode, hold down iPod Button and press Button

For Composite Video Mode, you must switch to it each time you dock your iPod/iPhone.

Using Video Out Jacks

1. Connect a 3.5 mm audio plug from a standard stereo audio cable (not included) to the Line-in jack in

the back of the unit and connect the other end to the headphone or line-out jack on your audio device.

2. Press the Button to turn on the unit (release when white light appears).

3. Press the Button to listen to audio via aux line-in. Make sure there is no playing iPhone or iPod

docked in the unit or you will hear audio from both devices.

4. Use the Volume Buttons to adjust volume. You may wish to adjust the volume on your audio

device, too.

5. When done listening, press and release the Button to turn the unit off. Remember to turn off

your audio device, too.

NOTE: the Button only works in Bluetooth or iPod modes. It does not control aux line-in devices.

Playing Audio via Aux

Y PB PR

For component video,

use the three jacks on rear

Y PB PR

For composite video,

use only the center jack

connect to component

video in jack on your TV

connect to composite

video in jack on your TV