User's Manual

Intelligent Home Solutions

Model: iSPR4

Quick Start Guide

Open the iHome Control app

and tap the “ ” beside the

SmartPlug you want to pair

Scroll down and tap:

initiate remote control pairing

Choose any of the four remote

buttons you want to pair

Press the ON button ﬁve times

Press the OFF button. If the

SmartPlug turns o, pairing was

successful. If not, repeat from step

Questions?

1.800.288.2792

www.ihome.com

FRONT

Remove plastic pull tab from battery

door before proceeding

Remote control setup requires an iSP6

or iSP8 SmartPlug connected to WiFi

Keep remote control within 15 ft. of

SmartPlug during pairing

Enable Pairing Mode on SmartPlug

ON OFF

START HERE

Send Pairing Commands

Send Remote Pairing Command

Quick Start Guide

Model: iSPR4 QSG (English)

Size: 65mm x 155mm

Date : Mar 1 , 2016

Pages: 1

Helpful Facts

PAGE 1
Model: iSPR4 QSG (English) Size: 65mm x 155mm Date : Mar 1 , 2016 Pages: 1 Helpful Facts FRONT Model: iSPR4 Intelligent Home Solutions Quick Start Guide START HERE Remove plastic pull tab from battery door before proceeding Remote control setup requires an iSP6 or iSP8 SmartPlug connected to WiFi Keep remote control within 15 ft.
PAGE 2
BACK Helpful Facts Multiple SmartPlugs can be programmed to use the same remote control button. This allows a group of plugs to be triggered at the same time with a single press (all plugs must be within range of remote control). The SmartPlug will retain remote control pairing information even through power outages and software resets. Please use the iHome Control app to delete remote control pairing info. The LED at the top of the remote will blink green when a button is pressed.