Application Guide

First Use Instructions of USB3.0 video capture card
Steps to use USB capture card for the first time
1.1 video capture card is connected to the USB3.0 interface through the cable；
1.2 Turn On the computer; and do not open related software.
1.3 Computer automatically completes the UVC drive. Check the auto install icon
in the lower right corner of the computer, see the driver installation process, if the
icon "√" all appear, then installation is successful. The video driver and audio driver
will appear in the device manager;
Tips:
(1) Do not open any related software before drive is installed automatically.
(2)W8, W10, Mac drive free in the local disk, need not connect to WLAN, about
5 seconds completed automatically.
(3) W7, XP free drive in Microsoft's official website, need to connect to the
Internet, about 3 minutes automatically finished, If the network is slow, it may
be more than 5 minutes. Please wait patiently until the installation is successful,
Go on to the next step.
1.4 Open the related software from computer to start