User's Manual

4
Safety and maintenance
Risk of damage
Please make sure that the piece of equipment to which your microphone
and PSU will be connected fulfils the safety regulations enforced in your
country and is fitted with a ground lead.
Cleaning the microphone
After every use, clean the microphone with a dry, soft cloth tissue and store it in a solid case or a
zipper pouch.
Technical Specifications
Capsule
Hand-crafted 1" diaphragm true condenser capsule
Polar patterns
9 (omni, cardioid, figure-8 with three additional steps between each)
Tube complement
1x 12AU7 (ECC82)
Frequency range
20 – 20,000 Hz
Sensitivity
16 mV/Pa (-36 dBV)
Gain
-12 / 0 / +12 dB, switchable
Max. SPL (0.5% THD)
151 dB
SPL
Equivalent noise level
18 dB(A)
Dynamic range
133 dB
Signal-to-noise ratio
76 dB
Low cut filter
40 / 80 Hz, 12 dB/Oct, switchable
Electrical impedance (floor box output)
30 Ohms
Recommended load impedance
>2k Ohms
Connectivity
3-pin male XLR connector
Power requirement
Floor Box / PSU (included)
Dimensions
Microphone
Diameter 62 mm (2.44 in.) Length 240 mm (9.45 in.)
Floor Box / PSU
356 x 135 x 100 mm (14.02 x 5.31 x 3.94 in.)
Weight
Microphone
989 g (34.90 oz.)
Floor Box / PSU
3905 g (137.79 oz.)