User Manual

RF PRO ASSEMBLY MANUAL
sE Electronics RF Pro Assembly + Use
Thank you for purchasing an sE Electronics RF Pro! We hope it helps make
your tracks sound great - no matter WHERE you’re recording.
STEP ONE
The fi rst step is to attach
the hardware to the stand,
which is done by loosening
the metal clamps (a), fi tting
the stand between them, and
tightening the key (b) for a
secure fi t.
If your stand’s diameter is
very large or very small, you
may have to adjust the large
threaded nut (c) opposite the
turning key to fi t.
STEP TWO
Next, attach the support rod
(d) to the fi lter by screwing it
into the socket on the bottom
edge (e). Tighten the nut using
the wrench supplied in the box.
a
b
c
d
e