User Manual

Microphone Manual
Safety Precautions
PLEASE READ THESE NOTES CAREFULLY
BEFORE USING YOUR MICROPHONE
WARNING
Always follow the basic precautions listed below to avoid the possibility of serious injury or even death
from electrical shock, short circuiting, damages, re or other hazards. These precautions include the
following:
• The power supply (if included with this microphone) contains no user-serviceable parts. Do not attempt to
disassemble or modify the internal components of the power supply in any way.
• Do not expose the microphone to rain, use it near water or in damp or wet conditions.
• If the power cord or plug becomes frayed or damaged, or if there is a sudden loss of sound during the use
of the microphone or any unusual smells or smoke should appear to be caused by it, turn the power switch
off immediately, disconnect the mains plug from the wall and have your microphone inspected by a qualied
technician.
• Only use the voltage as specied as correct for the microphone supply.
• Always attached the three-pin attachment plug for the power supply to a properly grounded power source.
• Check the mains plug periodically and remove any dirt or dust that may have accumulated on it.
• Do not place the power cord near heat sources such as heaters or radiators and do not excessively bend
or otherwise damage the power cord, place heavy objects on it or place it in a position where anyone could
walk or trip over, or roll anything over.
• When removing the power cable from either the power supply or the wall outlet, please do not jerk or pull on
the power cord. Always remove the cord by holding the plug itself.
• Always connect the power supply to a direct outlet and not an extension cord. Doing so may result in an
inadequate power supply for the unit to operate at specied levels.
• Always remove the plug from the outlet when the power supply is not in use for extended periods of time
(longer than two weeks). Also remove the plug from the outlet during any electrical storm.
• Do not expose the microphone or power supply to any excessive dust or vibrations or extreme cold or heat.
This includes but is not limited to: a car on a hot day, direct sunlight for long periods of time or near a heater
or a radiator.
• Our power supplies are made for international use, so they all come with a voltage switch. This switch
can be located on the back of the unit next to the on/off switch. You will have a selection between 115V or
230V. Please make absolutely sure that you have the correct voltage selected for your outlet as a mistake in
selection could cause serious damage to the power supply and/or the microphone that is connected.
• sE Electronics cannot be held responsible for any damage caused by improper use or modications of the
microphone or power supply.
• sE Electronics cannot provide schematics, wiring diagrams or any other technical documents to anyone
outside of our distribution partners and authorized sE repair centers.
For support or service, please contact your local sE distributor
or email [e-mail]