User's Manual

Sejin Electron Inc.
Sejin Electron Inc.Sejin Electron Inc.
Sejin Electron Inc.
FCC NOTICE
FCC NOTICEFCC NOTICE
FCC NOTICE
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC FULES.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC FULES.THIS DEVICE COMPLIES WITH PART 15 OF THE FCC FULES.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC FULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION:
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION:OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION:
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST A
(2) THIS DEVICE MUST A(2) THIS DEVICE MUST A
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
CCEPT ANY INTERFERENCE RECEIVED,CCEPT ANY INTERFERENCE RECEIVED,
CCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED
INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIREDINCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED
INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED
OPERATION.
OPERATION.OPERATION.
OPERATION.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures :
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit difference from that to which
the receiver is connected.
● Consult the dealer of an experienced radio/TV technician for help.
NOTE : Modifications not expressly approved by the manufacturer could void the
user's authority to operated the equipment under FCC rules.