User's Manual

SALCOM 12-90 PAGING TRANSCEIVER AND STORE FORWARD REPEATER Issue 1290UB 0211
Sea Air and Land Communications Ltd Page 21
WARRANTY
Our Products are warranted for a period of 12 months from date of purchase against
faulty materials and workmanship. Should any fault occur the unit should be returned
to the vendor, freight pre-paid. Please include a description of the fault to assist with
prompt return. Any unauthorized alterations or repairs will invalidate the warranty.
DISCLAIMER
All information provided in this document is carefully prepared and offered in good faith
as a guide in the installation, use and servicing of our products. Installers must ensure
that the final installation operates satisfactorily within the relevant regulatory
requirements. We accept no responsibility for incorrect installation. We reserve the right
to change products, specifications, and installation data at any time, without notice.
SPECIFICATION
Frequency Bands UHF: 440-479MHz
Enclosure. Aluminium. 77 x 101 x 30mm.
Supply Voltage 10v to 17v, Nominal 12V
Inputs and Outputs One relay output and 2 inputs.
Current drain Receive average 30mA plus 18mA when relay energised.
Transmit average(into matched 50 ohm aerial )90mA.
Relay contacts 1Amp @24VDC (Not suitable for 240VAC connection)
Temperature limits -10 to +50degC
Environmental protection Needs protection from weather
Frequency selection method Synthesized, user selectable.
RX sensitivity Approx -121dBm
Tx Power +18dBm.
Rx Bandwidth 10kHz (suitable for 12.5kHz channel operation)
Serial Connection 9600 Baud N:8:1 (for changing unit parameters and
message output)
Aerial connection BNC.
Paging protocol POCSAG 512 or 1200 baud
SEA AIR & LAND COMMUNICATIONS LTD
10 Magdala Place, Middleton, Christchurch 8024,
PO Box 76237 Northwood 8548, Christchurch, New Zealand
P: [phone] F: [phone] E: [e-mail]
Visit us at www.salcom.co.nz