User`s manual

Section 6: Configure Outputs
59
Serial Data Output
SEASAVE can output converted data in engineering units to a serial port on
your computer.
To enable and set up serial data output, click Configure Outputs. In the
Configure Outputs dialog box, click the Serial Data Out tab:
Make the desired selections. Click OK or click another tab in
Configure Outputs.
Rate at which data for selected variables is
converted to engineering units and sent to
COM port. Time between updates interacts
with instrument’s data output baud rate and
number of output variables selected.
SEASAVE will not work properly if data is
presented to COM port faster than COM port
can transmit it at selected baud rate. For full
rate data, set to 0.
Selected variables and number of decimal points to
right of decimal place for output data. Click Select
Variables to change. Dialog box with list of
variables appears; select desired variables and
number of decimal places to right of decimal point
for each variable, and click OK.
Output converted data to serial port defined on
Serial Ports tab (SEASAVE applies calibration
coefficients to raw data to calculate converted
data in engineering units).