Installation manual

CONTROL PANEL INSTALLATION
►►► Prior to mounting the Control Panel, connect 1/4” hose to the Pre-fi lter Gauge on the back of the
Control Panel. Leave the hose loose for connection to the Pre-fi lter Housing later.
❶ Mount the Control Panel in a convenient location;
the panel should be easily accessible and you
should have a clear view of the gauges when
you’re running the watermaker. It should be as
close as possible to the Membrane and to the High
Pressure Pump.
►►► Make sure the panel is mounted securely to
a solid surface.
❷ Mount the Wiring Harness near the Control Panel (but not below the panel, as it will be obscured by
hoses).
❸ Run 12-gauge wire from a dedicated 10 amp breaker to the red wire on the barrier strip.
Sea Clear Watermakers™ Manual - Version 1.1-G Page 25
On many boats, a convenient location for the Control Panel is a cockpit locker bulkhead. This
provides easy access to controls and hose runs to the bucket are kept short.