Installation manual

Once the pump has been mounted and the belt has
been installed, you’re ready to make the electrical
and plumbing connections for the High Pressure
Pump.
❶ Fill the pump with 9.81 oz. ISO 100 - NA 30 weight
hydraulic oil.
❷ Connect the [+] wire from the magnetic clutch to
the wiring harness on the Control Panel using 12-gauge tinned wire.
❸ If the generator is not grounded to the [-] terminal of the battery, you will need to run an additional
wire from the pump to your [-] battery buss. (In most cases, this will not be required.)
High Pressure Pump Fittings
See “Swagelok High Pressure Fitting Installation” on page 29.
Sea Clear Watermakers™ Manual - Version 1.1-G Page 28