Operating instructions

48
Periodic Inspection Chart
NOTE: Some items are included in the PRE-OPERATION CHECKS and not nec-
essarily repeated in this chart.
➀ Every 10 hours in salt water use.
➁ These items have to be initially checked after 25 hours. Thereafter, servicing
to be made as specified in this chart.
➂ Daily flushing in salt water or foul water use.
DESCRIPTION
FREQUENCY
First
10
hours
Every
25
hours
Every
50
hours
Every
100
hours or
seasonally
To be
performed
by
Lubrication/corrosion protection
➀✔ OPERATOR
Engine ignition timing
✔ DEALER
Spark plug replacement ✔ DEALER
Throttle/choke cables, inspection/lubrication ➀✔ OPERATOR
Carburetor adjustment including choke/
throttle cable adjustments
✔ DEALER
Oil injection pump adjustment ✔ DEALER
Fuel filter and oil filter inspection ✔ DEALER
Fuel filter and oil filter replacement
✔ DEALER
Fuel tank straps ✔ OPERATOR
Oil tank straps ✔ OPERATOR
Engine head bolts, retorque ✔ DEALER
Engine counterbalance shaft oil level (if applicable)
✔ DEALER
Steering system ✔ DEALER
Reverse system/reverse cable adjustment ✔ DEALER
Fastener tightening (flame arrester, carburetor(s),
engine mount, exhaust system, etc.)
✔ DEALER
Muffler, battery and reservoir fastening devices ✔ OPERATOR
Fuel lines, check-valve and fuel system
pressurization
✔✔✔ ✔ DEALER
Fuel vent line pressure relief valve inspection
✔ DEALER
Inspect/clean engine drain tube ➀✔ DEALER
Battery condition ✔ DEALER
Electrical connections (battery, starter, etc.)
✔ DEALER
Monitoring beeper
✔ DEALER
Jet pump reservoir oil level/oil condition ✔ Replace DEALER
Jet pump cover pusher inspection ✔ DEALER
Impeller condition and impeller/wear ring clearance
✔ ➁ DEALER
Drive shaft boot and spline condition (if applicable)
✔ ➁ DEALER
PTO flywheel and seal carrier lubrication (if applicable) ✔ OPERATOR
Water intake grate condition ✔ ➁ OPERATOR
Hull condition
✔ OPERATOR
Cooling system flushing
✔➂ OPERATOR
Smo2001-001a.book Page 48 Tuesday, May 23, 2000 2:18 PM
www.SeaDooManuals.net