Specifications

F22E02Y
1
1. Hose properly connected
Insert a funnel into the temporary hose
and pour in 1.3L (1.4 U.S. qt) of undi-
luted antifreeze (100% concentration)
until water/antifreeze mix flows out of
the cooling system bleed outlet. Use
a container to collect water flowing.
1
F22L0HZ
COOLING SYSTEM BLEED OUTLET
1. Water/antifreeze mix will flow out
from this hole
Place a container at rear of watercraft
to collect the water/antifreeze mix.
Remove hose pinchers from engine
drain hoses.
NOTE: Most of the antifreeze will
drain out when removing the hose
pinchers. ALWAYS DISPOSE OF AN-
TIFREEZE IN ACCORDANCE WITH
YOUR LOCAL LAWS AND REGULA-
TIONS.
Remove the temporary hose from
engine and reinstall the water supply
hose to the cylinder head.
Remove hose pincher from engine
outlet hose.
Procedure for Exhaust Pipe
and Muffler
Disconnect hose as shown.
F22E06Y
1
1. Disconnect hose from T-fitting
Raise the hose as high as it will go and
hold in this position.
Insert a funnel into the hose then
pour 1.2 L (1.3 U.S. qt) of undiluted
antifreeze (100% concentration) while
keeping the hose as high as possible.
CAUTION: It is important to keep
thehoseashighaspossiblewhile
pouring antifreeze in order to en-
sure that it reaches the end of the
exhaust pipe and avoid severe dam-
age.
88
______________________
www.SeaDooManuals.net