Technical data

Section 04 ENGINE (2-STROKE)

Subsection 07 (EXHAUST SYSTEM)

To ensure pipe end is well inserted in muffler, measure the distance as shown in the following illustration.

F22D0KS

A.322mm(12.68in)

Insert foam under expansion pipe. Ensure foam

is not against muffler bellow.

Position foam under bracket edge so that it is prop-

erly retained.

F22D0LA

1. Bracket edge

2. Foam

Rotate expansion pipe to position its T-fittings ver-

tically.

CAUTION: If T-fittings were not installed verti-

cally, water ingestion might occur when water-

craft tips over.

Tighten front clamp no. 2 as follows.

– Ensure to align expansion pipe with tuned pipe

so that their ends are in contact all around.

– Tighten clamp while maintaining expansion pipe

and tuned pipe together.

– Torqueclampto11N•m(97lbf•in).

– Ensure there is a gap between clamp ends.

Otherwise, try another clamp.

F22D0MA

A. Clamp ends must have a gap here

Ensure there is a gap between hose at front T-fit-

ting and fuel tank.

20 smr2004-3D