Technical data

Section 14 STEERING SYSTEM
Subsection 01 (STEERING SYSTEM)
Steering Cable
Remove screws no. 25.
F22K13A
1
1. Srews removed
Remove retaining block no. 26.
Remove ball joint no. 28 and adjustment knob
no. 29 from cable.
Disconnect ball joint no. 27 from jet pump nozzle
then from cable.
Use steering cable tool (P/N 295 000 145) and re-
move nut no. 44, then remove half rings no. 45
and O-ring no. 30.
Raise steering pole.
Cut locking ties as required to allow puling out
steering cable.
Remove steering pole to be able to pull steering
cable out of bilge. See below.
Steering Pole
Raise and lock steering pole with its retainer.
Cut locking ties as required then pull throttle cable
out of steering pole.
Pull wiring harness out of pole.
Completely release spring no. 31 preload.
F22L14A
3
4
1
2
1. Return spring
2. Adjustment
3. To increase preload
4. To reduce preload
Lower steering pole.
Remove front cover in the following step order.
CAUTION: Work carefully when releasing lock-
ing tabs from cover to avoid damaging cover.
Remove side screws.
F22K14A
68 smr2004-3D